Table of Contents
Advertisement
10BaseT LAN Connector
The LAN port is an 8-pin modular connector that provides a
10BaseT ethernet LAN interface. This interface is used for SNMP
and TELNET management and can also route non-management
data to any of the IP addresses known to the Express 5210. When
illuminated, the
proper connection to a 10BaseT hub. The pin assignments for this
connector are listed in Table A-3 of the appendix Pinouts.
DTE Connectors
Connect a DTE device to the
DTE cable or an ADTRAN V.35 DTE adapter cable. The maximum
cable lengths recommended are 50 feet for the EIA-232 and 100 feet
for the V.35. The pin assignments are listed in Table A-4 of the
appendix Pinouts.
The V.35 adapter cable is recommended for use with data rates
above 19.2 kbps. A low capacitance EIA-232 cable works up to
56 kbps. The DTE port is configured through the front panel or the
VT 100 control port and can operate in asynchronous or
synchronous mode. V.35 pin assignments are given in Table A-5 of
the appendix Pinouts.
61200208L1-1
LED (located on the rear panel) indicates
Link
connector using either an EIA-232
DTE
Express 5210 User Manual
Chapter 2. Installation
2-5
Advertisement
Table of Contents
