Llc2 Busy Timeout (Busy To); Llc2 Reject Timeout (Reject To); Llc2 Keep-Alive Timeout (Ka To); Priority Queue Ratio (N:1) (Queue Ratio) - ADTRAN Express 5210 User Manual

LLC2 Busy Timeout (BUSY TO)

Length of time the LLC2 protocol will wait for a remote device to
clear a busy state before querying it with an RR (receiver ready)
command.

LLC2 Reject Timeout (REJECT TO)

Maximum time the LLC2 protocol will wait for a reject response
after issuing a reject command.

LLC2 Keep-Alive Timeout (KA TO)

Optional tool for detecting the status of an LLC2 connection.

Priority Queue Ratio (N:1) (QUEUE RATIO)

Define the ratio that SDLC frames have over other protocols. SDLC
protocols are processed each time the network port transmitter is
serviced. Other protocols are processed every N times the SDLC
protocol is processed. Set to 1 to enable equal priority.

PVC Options (PVC CONFIG)

The PVC O
dial backup applications. Normally, when an Express 5210 sends
data on a particular DLCI, the frame relay switch maps that DLCI
to the appropriate DLCI at the far end. During dial backup, the
frame relay switch no longer exists in the data path, so the mapping
must be done at the receiving end of the data path.

DLCI

Enter the DLCI that data is received on during non dial backup
periods (local DLCI). For an example of this setup, see Figure 9-3.
61200208L1-1
table is used to re-map incoming DLCIs during
PTIONS
Express 5210 User Manual
Chapter 9. Network Port Configuration
9-7