Vt 100 Terminal Connection And Operation - ADTRAN Express 5210 User Manual

Chapter 3. Menu Navigation

VT 100 Terminal Connection and Operation

To control the Express 5210 using a VT 100 terminal, perform the
following procedure:
1.
2.
3.
4.
5.
In the lower left-hand corner of the terminal screen, L, R, or T is dis-
played, indicating the type of interface the current screen represents (lo-
cal, remote, or TELNET).
When using Microsoft Hyperterminal, set the F
3-2
Set the Express 5210 baud rate to match the terminal through
the front panel (default rate is 9600 bps). Select
C P .
ONTROL ORT
Using the provided VT 100 terminal adapter cable, connect the
port of a VT 100 compatible terminal or equivalent to the
COM
eight-pin modular jack labeled
Express 5210. This connection is used for both local and remote
configuration.
Open the connection and press the terminal keyboard's
key repeatedly until the first menu appears.
Pressing any key selects L
configure the Express 5210 unit connected to the terminal.
Pressing ^R (Ctrl R) selects R
configure a remotely located Express 5210 unit. For remote
applications, enter the DLCI (data link connection identifier) of
the remote unit at the prompt. Then press
Enter the password. The factory default password is
lower-case). The main menu will appear, as shown in Figure
3-1.
Express 5210 User Manual
1
on the rear of the
CONTROL
L , which is used to
OCAL OGIN
, which is used to
L
EMOTE OGIN
.
Enter
to T
ONT
C , then
ONFIG
Enter
(all
adtran
.
ERMINAL
61200208L1-1