Physical Layer Options (Phys Lyr Opts) - ADTRAN Express 5210 User Manual

Chapter 7. DTE Port Configuration

Physical Layer Options (PHYS LYR OPTS)

Interface Type (INTERFACE)
Select the connector type for the
EIA-232 and V.35.
Bit Rate
Set the operating speed of the
device.
The bit rate selections vary depending on the speed selections made for the
Network
card is required.
Data Bits
Set the byte length to match the connected asynchronous device.
The choices are 7 and 8.
Parity
Select even, odd, or no parity information. Set to match the
connected asynchronous device.
Stop Bits
Select one or two stop bits. Set to match the connected
asynchronous device.
Hardware Flow Control
When set to O
stopping the data being transmitted from the DTE device to the
Express 5210.
7-20
DTE
port. Also, for rates higher than 56/64 kbps, the External DCE
the Express 5210 disables CTS, temporarily
N
Express 5210 User Manual
interface. The choices are
DTE
interface to match the connected
61200208L1-1