Table of Contents
Advertisement
Chapter 7. DTE Port Configuration
N392 and N393
These parameters define the error threshold for the UNI formed by
the Express 5210
the error threshold is met, the S
which indicates a service-affecting condition. This condition is
cleared once N393 consecutive error-free events are received. N392
defines the number of errors required in a given event window,
while N393 defines the number of polling events in each window.
For example:
If N392=3 and N393=4, then if three errors occur within any four
events the interface is determined I
The status of the connection can be viewed in the S
under DTE P
A
CTIVE
Management DLCI (MGMT DLCI)
Enter the management data link connection identifier. The
M
ANAGEMENT
DTE device and the Express 5210 to carry SNMP and TELNET
packets to/from the Express 5210 on the
following section Guidelines for Configuring IP Addr, Subnet Mask,
and Mgmt DLCI for more information.
Guidelines for Configuring IP Addr, Subnet Mask, and Mgmt
DLCI
If the attached router or FRAD is used to route SNMP/TELNET
frames to the Express 5210, set the M
value that identifies the virtual circuit between the router/FRAD
and the Express 5210. The router/FRAD must also be configured
to route the Express 5210 IP A
A
DDRESS
M
ANAGEMENT
Interfaces on page 12-7).
Setting the IP A
DLCI to a value not used by the attached frame relay device
disables this feature.
7-6
port and the attached frame relay device. If
DTE
S
S
ORT
IGNALING
once the threshold is no longer exceeded.
DLCI is a special DLCI used between the attached
and S
M
for the
UBNET
ASK
DLCI interface must also be set (see the section
to 0.0.0.0 and setting the M
DDRESS
Express 5210 User Manual
S
is changed to D
IGNAL
TATE
.
NACTIVE
TATISTICS
. The status will return to
TATE
port. See the
DTE
DLCI to a unique
ANAGEMENT
to this DLCI. The IP
DDRESS
port or the
10BaseT LAN
ANAGEMENT
,
OWN
menu
61200208L1-1
Advertisement
Table of Contents
