Table of Contents
Advertisement
Network Name Entries
Logical network interfaces appear in the N
one of the following ways:
•
•
•
The only way to delete items from the N
through the N
N
ETWORK
D
ISABLED
IP Interface on page 9-9 for more information.
RIP Selections
Selections in this menu vary depending on selections made for
M
ODE
Selections available for RIP M
Mode
61200208L1-1
Through configuration of the DTE port.
When setting up the DTE port for SDLC, T
T
A
protocol, the O
RANSPARENT
SYNC
a logical network interface.
Through configuration of the network port.
When setting up the PVC O
C
, setting IP I
ONFIGURATION
logical network interface for that entry's DLCI.
Through the frame relay network.
DLCIs are learned through full status messages received from the
frame relay switch.
C
ETWORK
ONFIGURATION
-> PVC O
PTIONS
to delete the entry for the related DLCI. See the section
. See the following charts:
option
ODE
Select M
to configure RIP for this virtual circuit.
ODE
T
O
: RIP advertisements are periodically transmit-
X
NLY
ted, but received RIP packets are not processed.
R
O
: RIP advertisements are not transmitted, but
X
NLY
received RIP packets are processed.
T
R
: RIP advertisements are periodically trans-
X AND
X
mitted, and received RIP packets are processed.
Express 5210 User Manual
ETWORK
RANSPARENT
DLCI field identifies
UTGOING
table under N
PTIONS
to E
NTERFACE
NABLED
N
ETWORK
menu (C
ONFIGURATION
-> IP I
). Set IP I
NTERFACE
Chapter 12. IP Setup
N
field in
AME
BOP, or
ETWORK
identifies a
field is
AME
->
to
NTERFACE
12-9
Advertisement
Table of Contents
