Interface Type; Voice Coder; Line 1 And L2 Options (L1 And L2 Options) - ADTRAN Express 5210 User Manual

Interface Type

Select a two-wire or four-wire interface type (for the E&M voice
card only).

Voice Coder

Select the desired V
both the host and remote units. The choices are G.723 and
N
ETCODER

Line 1 and L2 Options (L1 and L2 OPTIONS)

Choose voice transmission settings for the two voice lines using the
following selections:
Receive TLP (RX TLP)
R
ECEIVE
+5
DBM
this field to D
Max Fax Rate
The Express 5210 supports fax up to 14.4 kbps. The maximum fax
rate may be set lower to reduce the amount of bandwidth used for
a fax. Rates are: O
14.4
Fax Gain
Used to set the gain during a fax session. This field should be left at
default unless fax problems are encountered.
Silence Suppression (SILENCE SUPP)
S
ILENCE
transmission by allocating bandwidth back to data during periods
of silence in a voice call.
61200208L1-1
C
OICE ODER
.
TLP is the receive gain setting with a range of -10
(in steps of 1 dB). The voice port can be disabled by setting
.
ISABLE
(fax not supported), 4800, 7200, 9600, and
FF
bps.
K
S reduces bandwidth during voice
UPPRESSION
Express 5210 User Manual
Chapter 8. Voice Configuration
. This setting must be the same for
to
DBM
8-5