Arp Cache; Routes - ADTRAN Express 5210 User Manual

Chapter 12. IP Setup
Option Description
Hops Enter the number of routers located between the Express 5210 and
the destination (maximum number of hops = 15).
Enabled Enable or disable the selected static route.
Advertise Enable in order to send the static route information to other devices.
The RIP option must be set to T
to work (see page 12-8).
.

ARP Cache

The ARP C
Address Resolution Protocol (ARP) cache. All resolved cache
entries time out after 20 minutes. Unresolved entries time out in 3
minutes.
Option Description
IP Address Displays the IP address used for resolving the MAC address.
MAC Address Displays the address used for resolving the ethernet address. If set
to all zeros, there is no resolution for that address.
Time Displays the minutes since the entry was last referenced.
Type Defines this entry as dynamic or static.
Interface Displays the interface upon which this entry was found.
Tx Pending Displays the number of transmit packets pending a reply.

Routes

The R
static routes, and routes learned through RIP. Learned routes can
be removed from the listing. See the following chart for
descriptions of the information given in this menu.
Option Description
IP Address Displays the IP address of the selected route's destination host or net-
work.
Netmask Displays the subnet mask applied to the destination address.
12-6
menu displays the contents of the Express 5210
ACHE
menu provides read-only information for local routes,
OUTES
Express 5210 User Manual
O or T R in order for this
X NLY X AND X
61200208L1-1