Address Table (Addr Table); Sdlc Protocol - ADTRAN Express 5210 User Manual

Address Table (ADDR TABLE)

DTE Port DLCI (DTE DLCI)
Enter the DTE P
mapping it to the corresponding N
translation is not required, set to the value of the corresponding
N
ETWORK
Network DLCI (NET DLCI)
Enter the N
mapping it to the corresponding DTE DLCI. Obtain DLCI
addresses from the service provider.
There should be one entry for every virtual circuit on the frame relay
port.
When building or editing an A
and
the
chart on page 3-7).

SDLC Protocol

SDLC is a synchronous, bit-oriented, full-duplex, Layer 2 protocol
used to connect SDLC devices to a frame relay network. At Layer
2, SNA networks use SDLC between FEPs (front-end processors)
and cluster controllers. This protocol selection provides Logical
Link Control Type 2 (LLC2). LLC2 defines the data link frame
header and supports the multiplexing of one or more data links to/
from separate service access points (SAPs). Type 2 provides
acknowledged, connection-oriented service. See Figure 7-5.
The PU (physical unit) A
O
UTGOING
each PU in the network. The PU A
address of each controller address attached to the port. The
O
UTGOING
network and is given by the service provider. The SSAP/DSAP
pairs are user-defined but should match between two
Express 5210s for each SDLC session.
61200208L1-1
DLCI into the protocol A
ORT
DLCI.
DLCI into the protocol A
ETWORK
keys on the front panel (described in the chart on page 3-9), or
Delete
and functions of the terminal interface (described in the
Insert Delete
DDRESS
DLCI are used to set up an end-to-end SDLC session for
DLCI determines the path across the frame relay
Express 5210 User Manual
Chapter 7. DTE Port Configuration
DDRESS
DLCI. If address
ETWORK
DDRESS
T , use the
DDRESS ABLE
, LLC2 SSAP, LLC2 DSAP, and
should match the
DDRESS
,
T
ABLE
T ,
ABLE
DTE
, , ,
Next Prev Add
7-7