Static Routes Table - ADTRAN Express 5210 User Manual

Static Routes Table

The S
modify, and delete routes using this menu. The following chart
describes the options found in the S
Option Description
IP Address Enter the IP address of the host or network device being routed to.
This entry identifies an individual host or an entire subnet. To address
an entire subnet, enter a value with the host portion equal to 0.
Netmask Enter the subnet mask of the selected route's destination host or net-
work. This number determines for routing the number of bits used in
the above-defined IP address. If a host address is desired for the IP
address, this field must be set to 255.255.255.255.
Gateway Enter the Gateway's IP address. If an IP packet with an unknown IP
address is received, the unit sends it to the Gateway (which is a router
or another frame relay device).
Interface Defines the interface to which IP packets with this address will be rout-
ed. These are either ethernet or frame relay DLCIs. The interface list
contains both logical and physical interfaces.
61200208L1-1
Figure 12-3. Static Routing Menu (Vertical View)
menu manages static IP routes. You can create,
R
TATIC OUTES
Express 5210 User Manual
Chapter 12. IP Setup
R menu:
TATIC OUTES
12-5