Table of Contents
Advertisement
Chapter 7. DTE Port Configuration
All PU A
that they match the PU A
DSAP/DLCI is used to make the connection across the frame relay
network.
Physical Layer Options (PHYS LYR OPTS)
Interface Type (INTERFACE)
Select the connector type for the
EIA-232 and V.35.
Bit Rate
Select the operating speed of the
The bit rate selections vary depending on the speed selections made for the
Network
card is required.
TD Clock Source (TD CLOCK SRC)
Set the clock source to internal or external.
Transmit Idle Code (TX IDLE CODE)
Enable the Express 5210 to transmit flags or all ones. When
operating the SDLC protocol, all O
7-8
for a port must be unique, but it is not necessary
DDRESSES
DDRESS
port. Also, for rates higher than 56/64 kbps, the External DCE
Express 5210 User Manual
at the remote end. The SSAP/
interface. The choices are
DTE
interface.
DTE
is the recommended option.
NES
61200208L1-1
Advertisement
Table of Contents
