Table of Contents
Advertisement
P
ROT
S
R
IG
OLE
S
T
IG
YPE
A
(F
CTIVE
RAME
R
)
ELAY
A
(PPP)
CTIVE
61200263L1-1.1
Read Security: 5
Displays the layer 2 protocol that this packet endpoint terminates. FR indi-
cates that this packet endpoint is configured for frame relay. TBOP indi-
cates that this packet endpoint is configured for Transparent Bit Oriented
Protocol (TBOP). PPP indicates this packet endpoint is configured for the
Point-to-Point Protocol.
Read Security: 5
Displays the frame relay signaling role for this packet endpoint. The follow-
ing options indicate the signaling role this packet endpoint is performing.
These settings are not applicable for PPP.
U
SER
Indicates user side of the User to Network Interface (UNI).
N
ETWORK
Indicates network side of the UNI interface.
B
OTH
Indicates that the packet endpoint is operating in Network-to-Network
Interface (NNI) mode.
Read Security: 5
Displays the frame relay signaling type used on this packet endpoint. These
settings are not applicable for PPP.
A
A
NNEX
Signaling using ITU-T Q.933-A.
A
D
NNEX
Signaling using ANSI T1.617-D.
LMI
Signaling using Group of Four.
Read Security: 5
Indicates that there is active frame relay signaling on this packet endpoint.
The packet endpoint must be defined by the frame relay configuration set-
tings to show active frame relay signaling.
This indicates the status of the PPP negotiation.
I
NITIAL
This is the first state of the LCP negotiation. This will usually go directly to
the starting state to start the PPP negotiation, unless the packet endpoint
has not been tied to a physical port in the dedicated maps.
S
TARTING
This packet endpoint is in this state when the physical line is down.
ATLAS Frame Relay User Manual
Chapter 4. Defining Packet Endpoints
4-3
Advertisement
Table of Contents
