Tools You Need At Hand - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

Before you start
Step
Transport
Maintenance
procedures
Transport
Assembly,
rack installation
Starting up
Table 1: Calculation of the average task duration
2.3

Tools you need at hand

When preparing the maintenance task, ensure that all required tools are
available according to the overview below. You will find a list of required tools at
the beginning of each procedure.
Screw driver /
Bit insert
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
Phillips
PH2 / (+) No. 2
hexagonal cross
SW5 / PZ2
Table 2: List of required tools and used screws
30
included Explanation
Transporting the server to the service table
no (where required) depends on local
customer conditions.
Maintenance procedures including
yes
preliminary and concluding software tasks
Returning the server to its installation site
no (where required) depends on local
customer conditions.
Reassembling the server, installing the
yes
server in the rack (if applicable)
Booting time depends on hardware and
no software configuration and may vary
significantly.
Screw
Upgrade and Maintenance Manual
Usage Type
Backup
M3 x 4.5 mm
drives,
(silver)
optical disk
drives,
C26192-Y10-C67
chassis
M3 x 6 mm
System
(silver)
board
C26192-Y10-C68
TX150 S8 / TX200 S7