Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual page 387

Ê If applicable, reinstall the rear fan as described in section
fan" on page 189.
"Installing the system fan holder" on page 77
Ê
"Reassembling" on page 64
Ê
Ê If applicable, activate TPM functionality in the system BIOS under Security >
TPM (Security Chip) Setting > Security Chip. For more information, refer to the
corresponding BIOS Setup Utility reference manual.
"Connecting the server to the mains" on page 74
Ê
"Updating or recovering the system board BIOS and iRMC" on page 87
Ê
Ê Reconnect all external cables.
"Switching on the server" on page 75
Ê
Ê Verify whether the backup data on the Chassis ID EPROM has been
restored to the system board as described in section
information backup / restore" on page
"Verifying the system time settings" on page 96
Ê
Ê Inform the customer about changed WWN and MAC addresses. For further
information, refer to section
on page 101.
Ê After replacing the system board in a server running Linux OS, update the
MAC address of the onboard network controller in the related NIC definition
file as described in section
environment" on page
"Enabling SVOM boot watchdog functionality" on page 94
Ê
"Enabling BitLocker functionality" on page 100
Ê
Ê Reconfigure your network settings in the operation system according to the
original configuration of the replaced controller (expansion card or onboard).
I
Configuration of network settings should be performed by the
customer.
For further information, please refer to section
settings recovery" on page
Ê If applicable,"After replacing the system board" on page 104
TX150 S8 / TX200 S7
"Looking up changed MAC / WWN addresses"
"Updating the NIC configuration file in a Linux
99.
376.
Upgrade and Maintenance Manual
System board and components
"Verifying system
89.
"Note on network
"Installing the rear
387