Removing A 3.5-Inch Hdd Module; Installing A 3.5-Inch Hdd Module; Concluding Steps; Replacing A 3.5-Inch Hdd Sas Backplane - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

7.3.6.2

Removing a 3.5-inch HDD module

Ê Remove the HDD module to be replaced from the server as described in
section "Removing a 3.5-inch HDD module" on page
7.3.6.3

Installing a 3.5-inch HDD module

Ê Install the new HDD module into the empty drive bay as described in section
"Installing 3.5-inch HDD modules" on page
7.3.6.4

Concluding steps

"Installing accessible drive and HDD bay covers" on page 71
Ê
"Performing a RAID array rebuild" on page 101
Ê
7.3.7

Replacing a 3.5-inch HDD SAS backplane

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
7.3.7.1

Preliminary steps

"Shutting down the server" on page 50
Ê
"Disconnecting the server from the mains" on page 50
Ê
"Getting access to the component" on page 51
Ê
"Removing the system fan holder" on page 76
Ê
"Removing 3.5-inch HDD modules" on page 159
Ê
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual
Hard disk drives / solid state drives
160.
156.
Hardware: 15 minutes
163