Sliding The Server Into The Rack - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

4.5.2.4

Sliding the server into the rack

Figure 21: Sliding the server into the rack
Ê Pull up on the locking latch on both telescopic rails (1).
Ê Slide the server inside the rack as far as it will go (2) until the quick release
levers lock into place.
Ê Reconnect all cables except the power cord to the server rear.
I
If you are not using a cable mounting arm (CMA kit), ensure that the
rear cables are long enough not to be strained or damaged when
extending the server out of the rack.
Use cable ties to prevent loose cables from blocking the air flow.
TX150 S8 / TX200 S7
Upgrade and Maintenance Manual
Basic hardware procedures
69