Setting Of Machine Positioning; Checking Of Set Up Positions - Dürkopp Adler 52 i Series Operating Instructions Manual

Setting of positioning motor
Operating Instructions 52Xi, 52Xi-75 - 00.0 - 10/2021
8.2.2

Setting of machine positioning

For the machine positioning the proximity switch on the hand wheel
is used together with the incremental sensor inside the motor.
These sensors permanently measure the angle between the ac-
tual position of the upper shaft and its reference position.
The reference position is set up according to the accompanying
Instructions manual. For the machine good function it is necessary
to set up the reference position in the most accurate way possible.
8.2.3

Checking of set up positions

Position 1
• Switch the network switch on
• Tread the pedal forwards shortly and release. The machine
stops in position 1 ( p. 94).
Position 2
• Tread the pedal forwards shortly first and then with heel fully
backwards until the machine stops. The machine stops in
position 2 ( p. 94).
95