Parameters Values - Dac Classic; Setting Of Machine Positioning; Position Definition - Dürkopp Adler 52 i Series Operating Instructions Manual

94
8.1.2

Parameters values - DAC classic

The machine class and subclass choice will be optioned in the
mean time of the SW installation from the external device "DON-
GLE".
The parameter input description you will find in the publication
given by the "DAC eco/classic Operating manual" producer or on
the website www.duerkopp-adler.com.
To be the machine function regular is to be set up the "reference
position" and sewing speed maximum.
Parameter
T08 00
T08 10
* depends on the type and machine equipment
8.2

Setting of machine positioning

8.2.1

Position definition

Position 1
The needle is down at seam-stop. The needle thread loop is caught
with the hook. The needle is high enough so that it is possible to
lift the foot to the height 12 mm.
Position 2
The needle is up after trimming. At the foot lifting to the height
12 mm the needle point must not protrude from the foot fitting
surface.
Reference position
On the needle motion downwards, the needle point is at the throat
plate level. This position is used to carry out the positioning motor
basic setting. The above mentioned positions are derived from
this as well as other positions not mentioned here.
Operating Instructions 52Xi, 52Xi-75 - 00.0 - 10/2021
Setting of positioning motor
Value Parameter description
* Sewing speed maximum (rpm)
- Reference position