Assembling Of Connecting Cable - Dürkopp Adler 52 i Series Operating Instructions Manual

Setup
Operating Instructions 52Xi, 52Xi-75 - 00.0 - 10/2021
6.9

Assembling of connecting cable

Pic. 35: Assembling of connecting cable
(1) - Connector
(2) - Connecting cable
If the machine is equipped with the positioning motor, the machine
head is electrically connected to the motor control box by means
of a connecting cable (1). The connecting cable is included in the
motor kits.
1. Remove the distribution case cover (3).
2. Install the connecting cable (2) according to the picture.
3. Connect the connector (1).
4. Mount the distribution case cover back again.
5. Pull the connecting cable (2) under the table top according to
the picture and connect it to the motor control box.
(3) - Distribution case cover
①
②
③
83