Checking The Lubrication; Performing A Test Run - Dürkopp Adler 52 i Series Operating Instructions Manual

96
9

Checking the lubrication

Before starting up the machine must be properly lubricated with
oil ( p. 64).

10 Performing a test run

When setup is complete, perform a test run to check the function-
ality of the machine.
.
WARNING
Risk of injury from moving, cutting and sharp
parts!
Switch off the machine before you replace the
needle, threading the thread, insert the bobbin
and adjust the hook thread tension.
Sewing test
1. Insert the needle ( p. 35).
2. Wind on the hook thread ( p. 39).
3. Insert the bobbin and thread hook thread ( p. 41).
4. Thread needle thread ( p. 38).
5. Set the thread tension to the sewing material being sewn
( p. 42).
6. Set the foot pressure to the sewing material being sewn
( p. 48).
7. Set the foot stroke to the sewing material being sewn
( p. 46).
8. Set stitch length ( p. 49).
9. Start the sewing test at low speed.
10. Gradually increase the speed until the working speed is
reached.
Operating Instructions 52Xi, 52Xi-75 - 00.0 - 10/2021
Checking the lubrication