Fortinet FortiGate FortiGate-1000A Administration Manual page 65

Fortinet fortigate fortigate-1000a: user guide
Hide thumbs Also See for FortiGate FortiGate-1000A:
Table of Contents

Advertisement

System Network
FortiGate-1000A/FA2 Administration Guide
To configure support for dynamic DNS services
1
Go to System > Network > Interface.
2
Select the interface to the Internet and then select Edit.
3
Select DDNS Enable.
4
From the Server list, select one of the supported dynamic DNS services.
5
In the Domain field, type the fully qualified domain name of the FortiGate unit.
6
In the Username field, type the user name that the FortiGate unit must send when it
connects to the dynamic DNS server.
7
In the Password field, type the associated password.
8
Select OK.
To add a ping server to an interface
1
Go to System > Network > Interface.
2
Choose an interface and select Edit.
3
Set Ping Server to the IP address of the next hop router on the network connected to
the interface.
4
Select the Enable check box.
5
Select OK to save the changes.
To control administrative access to an interface
For a FortiGate unit running in NAT/Route mode, you can control administrative
access to an interface to control how administrators access the FortiGate unit and the
FortiGate interfaces to which administrators can connect.
Controlling administrative access for an interface connected to the Internet allows
remote administration of the FortiGate unit from any location on the Internet. However,
allowing remote administration from the Internet could compromise the security of
your FortiGate unit. You should avoid allowing administrative access for an interface
connected to the Internet unless this is required for your configuration. To improve the
security of a FortiGate unit that allows remote administration from the Internet:
Use secure administrative user passwords,
Change these passwords regularly,
Enable secure administrative access to this interface using only HTTPS or SSH,
Do not change the system idle timeout from the default value of 5 minutes (see
set the system idle timeout" on page
To configure administrative access in Transparent mode, see
management interface" on page
1
Go to System > Network > Interface.
2
Choose an interface and select Edit.
3
Select the Administrative Access methods for the interface.
4
Select OK to save the changes.
68.
01-28011-0254-20051115
91).
"To configure the
Interface
"To
65

Advertisement

Table of Contents
loading

Table of Contents