Fortinet FortiGate FortiGate-1000A Administration Manual page 206
Fortinet fortigate fortigate-1000a: user guide
Hide thumbs
Also See for FortiGate FortiGate-1000A:
- Install manual (58 pages) ,
- Quick start manual (2 pages) ,
- Administration manual (458 pages)
Table of Contents
Advertisement
Policy
206
Figure 88: Standard policy options
Interface / Zone
Select the source and destination interface or zone for the firewall policy. Interfaces
and zones are listed and configured in System > Network. See
for information about interfaces. See
Source
Select the name of the source interface or zone for the policy. The source
interface or zone receives the packets to be matched by the policy.
Destination
Select the name of the destination interface or zone for the policy. Packets
matched by the policy exit the FortiGate unit from the destination interface
or zone.
Address Name
Select the source and destination firewall addresses for the firewall policy. Before
adding addresses to a policy, you must add them to the FortiGate firewall
configuration. To add firewall addresses, see
Source
Select the name of a firewall address or address group that matches the
source address of the packets to be matched with this policy.
Destination
Select the name of a firewall address or address group that matches the
destination address of the packets to be matched with this policy.
For NAT/Route mode policies where the address on the destination network is hidden
from the source network using NAT, the destination can also be a virtual IP that maps
the destination address of the packet to a hidden destination address. See
on page
230.
01-28011-0254-20051115
"Zone" on page 66
for information about zones.
"Address" on page
Firewall
"Interface" on page 55
213.
"Virtual IP"
Fortinet Inc.
Advertisement
Table of Contents
