Static Ip And Dynamic Dns Monitor; Pptp - Fortinet FortiGate FortiGate-1000A Administration Manual

VPN

Static IP and dynamic DNS monitor

PPTP

FortiGate-1000A/FA2 Administration Guide
The list of tunnels provides information about VPN connections to remote peers that
have static IP addresses or domain names. You can use this list to view status and IP
addressing information for each tunnel configuration. You can also start and stop
individual tunnels from the list.
Figure 139:Static IP and dynamic DNS monitor
Name
Remote gateway The IP address and UDP port of the remote gateway. For dynamic DNS
Timeout
Proxy ID Source The IP address of the host, server, or private network behind the FortiGate
Proxy ID
Destination
Bring up tunnel
and Bring down
tunnel icons
Page up and
Page down icons
FortiGate units support PPTP to tunnel PPP traffic between two VPN peers. Windows
or Linux PPTP clients can establish a PPTP tunnel with a FortiGate unit that has been
configured to act as a PPTP server. As an alternative, you can configure the FortiGate
unit to forward PPTP packets to a PPTP server on the network behind the FortiGate
unit.
For information about how to perform these tasks, see
procedures" on page
To enable PPTP and specify the PPTP address range
1 Go to VPN > PPTP > PPTP Range.
2 Enable PPTP and specify the address range.
The name of the tunnel.
tunnels, the IP address is updated dynamically.
The time before the next key exchange. The time is calculated by
subtracting the time elapsed since the last key exchange from the keylife.
unit. A network range may be displayed if the source address in the firewall
encryption policy was expressed as a range of IP addresses.
The IP address of the hosts, servers, or private networks behind the remote
FortiGate unit.
Start or stop the selected VPN tunnel. If you stop the tunnel, the remote
VPN peer may have to reconnect to establish a new VPN session.
Display the previous or next page of VPN-tunnel status listings.
285.
01-28011-0254-20051115
"PPTP configuration
PPTP
277