Selection Of Mc Model - Omron C200H-MC221 Operation Manual

Setting Parameters

8-8-1 Selection of MC Model

1, 2, 3...
The parameters that must be changed or reset are shown in the following table.
Parameters
Machine parameters Machine parameters
Coordinate parameters
Coordinate parameters
Feed rate parameters Feed rate parameters
Servo parameters
For items with no axis settings, set the same values for axes X and Y. The meth-
ods for setting individual parameters are explained below and on subsequent
pages in this section. The procedures are shown using the X-axis setting
screens as an example. To make the settings for either the Y axis, press the End
Key to display the Machine Parameter Edit, Feed Rate Parameter Edit, and Ser-
vo Parameter Edit menus, and select the axes that are to be edited.
It is assumed here that the MCSS has already been installed.
1. Turn on the power supply to the computer, and start up the MCSS.
2. Select "K:MC Models" from the System Setting Menu.
<CV500-MC421>
(
[Setup]
[MC model]
A:CV500-MC421
B:CV500-MC221
C:C200H-MC221
3. Select "C:C200H-MC221" from the MC Model Menu.
Item
Minimum setting unit
Display unit
Pulse rate
Positive and negative software Positive and negative software
limits limits
Reference origin offset value
Workpiece origin offset value
Maximum high-speed feed rate
Maximum interpolation feed rate 2,048.00
Origin search high speed
Origin search low speed
Maximum jog feed rate
In-position
MC model
)
Section 8-8
Set value
0.01
mm
1/100
X axis, negative: --50.00
X axis, positive: 600.00
Y axis, negative: --50.00
Y axis, positive: 500.00
0
0
2,048.00
204.80
20.48
204.8
5
Setup
ESC: previous
75