Omron C200H-MC221 Operation Manual page 116

Checking Operation From the Teaching Box
Executing Single-block Run
1, 2, 3...
102
When the PAUSE Key is pressed, program execution is paused and the pre-
vious screen is restored. Program execution is resumed by pressing the
START Key. The program cannot be executed while an error is in effect.
5. Press the CLR Key after the program has been completed. The menu for
selecting the operation mode will be restored. (The CLR Key is not effective
during program execution.)
1. Select "2.SINGLE RUN" from the menu.
2. Specify the program number. In this case, the program number is 001, so
just input "1." If the program number is already set to 001 after the execution
of cycle run, there is no need to enter anything here.
RUN|STATUS RUN
SIN|PROGRM P001
TK1|BLOCK
3. Press the START Key. The first block of program no. 001 will be executed. In
this case, since the first block is a comment, block N002 will be executed.
RUN|STATUS RUN
SIN|PROGRM P001
TK1|BLOCK
To halt the operation in progress, press the PAUSE Key.
4. When execution of the first block has been completed, "pause" status will go
into effect and program execution will be stopped. The number of the next
block to be executed will be displayed.
RUN|STATUS PAUSE
SIN|PROGRM P001
TK1|BLOCK
Press the PROG EXEC Key to execute the next block. Press the CLR Key to
return to the program number input screen. Then press the CLR Key again
to return to the operation mode menu.
RUN| SINGLE RUN
SIN|PROGRM P000
TK1|BLOCK N000
| RUN: START
Task 1 is displayed.
N002
|
N002
|
N003
| RUN: START
Section 8-18