Omron C200H-MC221 Operation Manual page 115

Checking Operation From the Teaching Box
Executing the Jog Operation
1, 2, 3...
Executing Cycle Run
1, 2, 3...
2. Press a number from 0 to 4 to select the number of axes to be reset.
[RT]
<ALL AXES>
RESET ERROR ?
The specified axis or axes are displayed here.
0: All axes
2: Y axis
1. Press the JOG Key. The Unit will go into jog mode and the following screen
will be displayed.
JOG|X
050|
2. To execute jogging along the X or Y axes, press any of the following six jog
feed keys: +X, +Y, --X, --Y. The specified axis will move in the specified direc-
tion, and the present position will be refreshed on the screen.
1. Press the PROG EXEC Key.
RUN|1.CYCLE RUN
2. Select "1. CYCLE RUN" from the menu.
3. Specify the program number. In this case, the program number is 001, so
just input "1."
RUN| CYCLE RUN
CYC|PROGRM P001
TK1|BLOCK
4. Press the START Key.
RUN|STATUS RUN
CYC|PROGRM P050
TK1|BLOCK
DRIVER
YES / NO
1: X axis
0.00
|Y 0.00
|
The override values are displayed
here. The default value is 50%.
Press the Up and Down Keys to
set the value from 10% to 100%
in increments of 10%.
|2.SINGLE RUN
|
|
RUN| CYCLE RUN
CYC|PROGRM P000
TK1|BLOCK N000
| RUN: START
Task 1 is displayed.
N000
| RUN: START
N010
|
Section 8-18
101