Angle Spacer - FUTABA T10PX Short Manual

Angle Spacer

The wheel mounting angle can be changed by using the optional angle spacer 5°.
- The angle spacer use the included four M2x5 mm hex screws.
- Obtain hex wrench./ Remove the battery.
- The length of the screws used at each part differs. When reassembling the steering wheel unit,
always use the specified screws.
Angle spacer
Adjust the angle with the position mark.
1
2
3
Four M2x5 screws for
angle spacer mounting
Angle spacer
M2×19
M2×10
M2×6
M2×19
M2×10
M2×6
M2×19
- Use the accessory screws and the transmitter screws.
- There are extra screws in the accessories.
- M2 x 5 screws are special size so be careful not to lose them.
- Do not overtighten M2×19 four screws.
27
APA uses the outside holes. The
mounting angle in the direction
of rotation can be adjusted.
Normal
screw
position
Screw mounting point
Screw mounting point
M2×5
M2×5
M2×5