Panasonic SC-HG1 Series Reference Manual page 139

(2) Creating module configuration (when using the CC-Link master/local module)
If a Windows® PC where the target CPU module and GX Works3 are already installed is connected via USB, you can load
the CPU module configuration.
Once the setup is complete, the Start XY of the CC-Link master/local module becomes the Start I/O No. (i_uStartIONo) of
the FB common input for this FB library. In the settings shown below (Figure 1.5.3-3), "H0000" becomes the input value.
Navigation window → [Parameter] → [System Parameter]
Figure 1.5.3-2: System parameters
Set the Start XY of the CC-Link master/local module to
the Start I/O No. (i_uStartIONo) of each FB.
Figure 1.5.3-3: System parameters (after reading the mounting state)
SC-HG1 Series FB Library Reference Manual for Mitsubishi MELSEC iQ-R series Sequencer
139/184
WUME-SCHG1IQRFB-1