Inserting The Sd Card And Saving The Fuel Cell Module Data - Viessmann Vitovalor PT2 Installation And Service Instructions For Contractors

Diagnosis and service checks
Fuel cell module
(cont.)
7.
A
1.
Fig. 82

Inserting the SD card and saving the fuel cell module data

1. Insert the SD card into the slot: See chapter
"Removing the SD card".
If the SD card has been inserted correctly, the LED
on the PCB flashes.
2. Use to select "04" on the programming unit.
3. Press SET to confirm.
112
8.
1. Remove cover
A .
2. Use to select "04" on the programming unit.
3. Press SET to confirm.
4. On the programming unit, use
5. Press SET to confirm.
6. When the LED on the PCB flashes, data recording
has finished. Remove the SD card from its slot.
7. Briefly push the SD card into the retainer.
The SD card is unlocked.
8. Remove the SD card.
4. On the programming unit, use
5. Press SET to confirm.
When the LED on the PCB goes off, data recording
begins.
6. Fit cover : See chapter "Removing the SD card".
A
to select "oFF".
to select "on".