Lockout Functions - Miller Dynasty 280 Series Owner's Manual

10-5. Lockout Functions

LOCK
CODE
+
OM-253086 Page 26
A complete Parts List is available at www.MillerWelds.com
�
Complete Parts List is available at www.MillerWelds.com
1
OFF
See Section 10-2 for information on how to
access Lockout Functions.
There are four (1-4) different lockout levels.
Each successive level allows the operator
more flexibility.
�
Before activating lockout levels, be
sure that all procedures and parame-
ters are established. Parameter adjust-
ment is limited while lockout levels are
active.
2
To turn On lockout feature, proceed as
follows:
1 Amperage Adjustment Control
2 Amperage Button (Voltage control in volt-
age-sense capable machines)
Press Amperage button to toggle between
the lock off and code off displays. Toggle
control until [CODE] [OFF] is displayed
Turn amperage adjustment control to select
a lockout code number. Select a number be-
tween 1 and 999. The number will appear on
the amperage, right, display.
280859-A �
Remember (write down) this code num-
ber, as you will need this number to
turn this feature off, or make changes
to your settings.
Toggle Amperage button until [LOCK] is dis-
played. You may now select a lockout level.
See table below for the degree of adjustabil-
ity associated with each lock level. Exit Ad-
vanced Functions according to Section 10-2.
To turn Off lockout feature, proceed as
follows:
Toggle Amperage button until Code is
displayed.
Use amperage adjustment control to enter
the same code number that was used to turn
on the lockout feature.
Press the Amperage button. The ammeter
display will turn to [OFF]. Lockout is now off.
Exit Advanced Functions according to Sec-
tion 10-2.
OM-253086 Page 61