Section 5 - Installation; Selecting A Location - Miller Dynasty 280 Series Owner's Manual

18 in. (460 mm)
5-1.

Selecting A Location

Movement
1-1. Selecting a Location
Location And Airflow
18 in. (460 mm)
18 in. (460 mm)
OM-253086 Page 22
�
Complete Parts List is available at www.MillerWelds.com
SECTION 5 – INSTALLATION
1
18 in. (460 mm)
3
3
2
18 in. (460 mm)
Do not move or operate unit where
it could tip.
Special installation may be re-
quired where gasoline or volatile
liquids are present - see NEC Ar-
ticle 511 or CEC Section 20.
1 Carry Strap
Use strap to carry power source only. Do not
use to lift power source when attached to
cart/cooler.
2 Lifting Handle
Use lifting handle to move and lift welder/
cart/cooler.
Do not use lift handle to lift unit
when gas cylinder and accessories
are connected.
3 Line Disconnect Device
Locate unit near correct input power supply.