Software Updates - Miller Dynasty 280 Series Owner's Manual

5-12. Software Updates

A. Downloading Software Updates
2-13. Software Updates
A. Reasons For Downloads Of Software Updates
B. Requirements
1
C. Software Installation
B. Installing Software Updates
1 2
2
Dynasty 280 DX Shown
�
Software updates may reset machine
back to default values.
Card Requirements:
32 GB max capacity SD memory card
required.
1 Memory Card Port
2 Indicator LED
Insert card containing new software into port
while machine is on, but not while welding.
�
Complete Parts List is available at www.MillerWelds.com
1
2
A. Software Installation
Inserting card while welding will interrupt the
welding process.
LED indicator blinks green when machine is
reading from or writing to the card, and the
meter displays go blank. The update time
may vary up to three minutes. Do Not re-
move card while LED is blinking green.
After successfully reading from or writing to
the card, the LED switches from blinking to
continuous green, and the meters illuminate.
The machine is now ready for use.
Reasons To Download Software Updates:
� To get the latest feature and software
improvements
updates.
� For all circuit board replacements, a
software update is required to ensure
proper unit operation.
� A software update is required to ensure
proper software expansion operation of
all purchased feature expansions.
Requirements
A computer with an SD memory card port, or
SD memory card reader is required to down-
load software updates.
32 GB max SD memory card.
The SD logo is a registered trademark of
SD-3C LLC.
How To Download Software Updates
In a web browser, go to
com/support/system-setup-and-software/tig-
software
Click System Installation Instructions
(PDF) and follow the instructions.
A complete Parts List is available at www.MillerWelds.com
1
2
273670-B
805496-A
Troubleshooting:
Indicator LED is blinking red: Error updating
273670-B software, or software is not compatible. Try
removing and inserting card.
Indicator LED is continuous red: Cannot
read card. Card might be bad.
with future software
www. millerwelds.
OM-253086 Page 33