Section 7 - Dynasty 280 Dx Operation; Dynasty 280 Dx Controls - Miller Dynasty 280 Series Owner's Manual

SECTION 4
SECTION 7 – DYNASTY 280 DX OPERATION
4-1. Dynasty 280 DX And Dynasty 280 DX Multiprocess Controls
7-1.

Dynasty 280 DX Controls

1
7
�
For all front panel button controls:
press button to turn on light and ena-
ble function.
�
Green on nameplate indicates a TIG
function, Gray indicates
function.
1 Standby Button
Use to put machine into low power con-
sumption mode.
�
This button can also be used to clear
some errors. See Section 11-5.
2 Amperage Adjustment Control
Use amperage adjustment control in con-
junction with applicable front panel function
buttons to change values for that function.
3 Memory Card Port And Indicator
OM-253086 Page 40
A complete Parts List is available at www.MillerWelds.com
�
Complete Parts List is available at www.MillerWelds.com
DYNASTY 280 DX OPERATION
4
This port is used to add features to the ma-
chine and update software to the boards
within the machine. Indicator is lit while card
is being accessed.
4 Voltmeter
a Stick
Stick and TIG - Displays actual rectified
average voltage when voltage is present at
the weld output terminals.
MIG/V-Sense (Multiprocess Models) - Dis-
plays output polarity while idle or adjusting
and actual voltage while welding.
While in the menu it is used to display pa-
rameter descriptions.
5 Ammeter
Stick and TIG - Displays preset amperage
while idle and actual rectified average am-
perage while welding.
3
5
280589-A
MIG/V-Sense (Multiprocess Models) - Dis-
plays preset voltage while idle or actual rec-
tified amperage while welding.
While in the menu it is used to display pa-
rameter selection options.
6 Amperage Button
Use this button in conjunction with the am-
perage adjustment control to set the aver-
age weld amperage or peak amperage if the
Pulser is active.
7 V-Sense Feeder (Multiprocess Models)
Use item 6 and 2 to set constant voltage
when the V-Sense Feeder - DC MIG
(GMAW/FCAW) process is selected.
2
6
OM-253086 Page 13