Lockout Functions; Lockout Levels Defined - Miller Maxstar 400 Owner's Manual

9-4.

Lockout Functions

LOCK
CODE

9-5. Lockout Levels Defined

Minimum Adjustability
Lock Level 1
Adjustable Locked
Panel Amps
Polarity (Dyn Only)
Process
Output
Pulser
Sequencer
Gas/DIG
Waveshape
.
A complete Parts List is available at www.MillerWelds.com
OFF
Degree Of Adjustability
Lock Level 2
Adjustable Locked
Panel Amps
Polarity (Dyn Only)
Process
Output
Pulser
Sequencer
Gas/DIG
Waveshape
1
2
Lock Level 3
Adjustable Locked
Panel Amps +/- 10%
Polarity (Dyn Only)
Process
Output
Pulser (on/off only)
Sequencer
Gas/DIG
Waveshape
See Section 9-1 for information on how to
access Lockout Functions.
There are four (1−4) different lockout
levels. Each successive level allows the
operator more flexibility.
.
Before activating lockout levels, be
sure that all procedures and para-
meters are established. Parameter
adjustment is limited while lockout
levels are active.
To turn On lockout feature, proceed as
follows:
1 Encoder Control
2 Amperage Button
Press Amperage (A) control to toggle
between the lock off and code off dis-
plays. Toggle control until [CODE] [OFF]
is displayed
Rotate Encoder to select a lockout code
number. Select a number between 1 and
999. The number will appear on the am-
perage, right, display.
.
Remember (write down) this code
number, as you will need this number
to turn this feature off, or make
changes to your settings.
Toggle Amperage control until [LOCK] is
displayed. You may now select a lockout
level. See table below for the degree of
adjustability associated with each lock
level. Exit Advanced Functions accord-
ing to Section 9-1.
To turn Off lockout feature, proceed as
follows:
Toggle Amperage control until Code is
displayed.
Use Encoder control to enter the same
code number that was used to turn on the
lockout feature.
Press the Amperage control. The amper-
age meter display will turn to [OFF]. Lock-
out is now off. Exit Advanced Functions
according to Section 9-1.
Maximum Adjustability
Lock Level 4
Adjustable Locked
Remote Amps
(min−panel)
Panel Amps +/- 10%
Polarity (Dyn Only)
Process
Output
Pulser (on/off only)
Sequencer
Gas/DIG
Waveshape
OM-275857 Page 61