Miller Dynasty 280 Series Owner's Manual page 7

EMF DATA SHEET FOR ARC WELDING POWER SOURCE
Product/Apparatus Identification
DYNASTY 280 DX (AUTO-LINE 208-575), CPS, CE
DYNASTY 280 DX (AUTO-LINE 208-575), CPS, VS, CE
Compliance Information Summary
Applicable regulation
Reference limits
Applicable standards
Intended use
Non-thermal effects need to be considered for workplace assessment
Thermal effects need to be considered for workplace assessment
Data is based on maximum power source capability (valid unless firmware/hardware is changed)
Data is based on worst case setting/program (only valid until setting options/welding programs are changed)
Data is based on multiple settings/programs (only valid until setting options/welding programs are changed)
Occupational exposure is below the Exposure Limit Values (ELVs)
for health effects at the standardized configurations
Occupational exposure is below the Exposure Limit Values (ELVs)
for sensory effects at the standardized configurations
Occupational exposure is below the Action Levels (ALs) at the
standardized configurations
EMF Data for Non-thermal Effects
Exposure Indices (EIs) and distances to welding circuit (for each operation mode, as applicable)
Standardized distance
ELV EI @ standardized distance
Required minimum distance
Distance where all occupational ELV Exposure Indices fall below 0.20 (20%)
Distance where all general public ELV Exposure Indices fall below 1.00 (100%)
Tested by: Tony Samimi
275608-B
Product
Directive 2014/35/EU
Directive 2013/35/EU, Recommendation 1999/519/EC
IEC 62822-1:2016, IEC 62822-2:2016
for occupational use
Head
Sensory
Effects
10 cm
0.12
1 cm
907514002
907514008
for use by laymen
(if NO, specific required minimum distances apply)
n.a
(if applicable and NO, specific measures are needed)
n.a
(if applicable and NO, specific signage is needed)
Health
Trunk
Effects
10 cm 10 cm
0.11 0.18
1 cm 1 cm
Date tested: 2016-02-18
Stock Number
YES NO
YES NO
YES NO
YES NO
YES NO
Limb (hand) Limb (thigh)
3 cm 3 cm
0.10 0.23
1 cm 1 cm
9 cm
124 cm