Output Control And Trigger Functions For Dx Models - Miller Dynasty 280 Series Owner's Manual

10-4. Output Control And Trigger Functions For DX Models

A. Remote (Standard), 2T, And 4TE Torch Trigger Operation
Current (A)
Current (A)
Current (A)
Current (A)
Initial Amps
Initial Amps
Initial Amps
Preflow
Initial Amps
Time
Preflow
Time
Preflow
Standard
Time
Preflow
Time
P/H
P/H
P/H
P/H
P/H = Push and hold trigger; R = Release trigger.
�
When a foot or finger remote current control is connected to the welding power source, initial amps, initial slope, final slope and final
amps are controlled by the remote control, not by the welding power source
Remote 2T
P/R
P/R
P/R
P/R
P/R = Push and release trigger.
�
If torch trigger is held more than 3 seconds, operation reverts to RMT STD (Remote Standard) mode.
Remote 4TE
P/R
P/R
P/R
P/R
P/R = Push and release trigger.
*Pushing and releasing during final slope will break the arc and go to postflow.
�
For first torch trigger push & release, if trigger is held more than 3 seconds, trigger cycle ends.
�
When a remote switch is connected to the welding power source, use the remote switch to control the weld cycle. Amperage is con-
trolled by the welding power source.
Application: Use 4T Momentary trigger method when the functions of a remote current control are desired, but only a remote on/off control
is available.
OM-253086 Page 58
�
Complete Parts List is available at www.MillerWelds.com
Main Amps
Initial Slope
Main Amps
Main Amps
Main Amps
Initial Slope
Initial Slope
Initial Slope
P/R
P/R
P/R
P/R
Final Slope
Final Slope
Final Slope
Final Slope
Final Amps
Final Amps
Final Amps
Final Amps
R
Maintained Switch
R
R
Maintained Switch
R
Maintained Switch
Maintained Switch
P/R
P/R
P/R
P/R
P/R *P/R
P/R *P/R
P/R *P/R
P/R *P/R
Postflow
Postflow
Postflow
Postflow
R
Foot Or Finger
Remote Control
R
R
Foot Or Finger
R
Foot Or Finger
Remote Control
Foot Or Finger
Remote Control
Remote Control
P/R
P/R
P/R
P/R