Section 9 - Maxstar 280 Dx Operation; Maxstar 280 Dx Controls - Miller Dynasty 280 Series Owner's Manual

SECTION 6
SECTION 9 – MAXSTAR 280 DX OPERATION
9-1.

Maxstar 280 DX Controls

6-1. Maxstar 280 DX Controls
1
�
For all front panel button controls:
press button to turn on light and ena-
ble function.
�
Green on nameplate indicates a TIG
function, Gray indicates
function.
1 Standby Button
Use to put machine into low power con-
sumption mode.
�
This button can also be used to clear
some errors. See Section 11-5.
2 Amperage Adjustment Control
A complete Parts List is available at www.MillerWelds.com
�
Complete Parts List is available at www.MillerWelds.com
MAXSTAR 280 DX OPERATION
4
Use amperage adjustment control in con-
junction with applicable front panel function
buttons to change values for that function.
3 Memory Card Port And Indicator
a Stick
This port is used to add features to the ma-
chine and update software to the boards
within the machine. Indicator is lit while card
is being accessed.
4 Voltmeter
Displays actual voltage when voltage is
present at the weld output terminals. It is
3
5
247216-D
also used to display parameter descriptions
while in the menu.
5 Ammeter
Displays actual amperage while welding and
preset amperage while idle. It is also used to
display parameter selection options while in
the menu.
6 Amperage Button
Use this control in conjunction with the am-
perage adjustment control to set the weld
amperage or peak amperage if the Pulser is
active.
2
6
OM-253086 Page 21
OM-253086 Page 51