Accessing User Setup Menu - Miller Dynasty 280 Series Owner's Manual

[IND] [30%]
Parameter/Setting
Display
[BAL] [75%]
[FREQ] [120H]
4-3.

Accessing User Setup Menu

7-3. Accessing User Setup Menu
3
USER
6
Parameter/Setting Display
[TUNG] [3/32]
�
Complete Parts List is available at www.MillerWelds.com
Gas/DIG Control With Optional V-Sense Feeder
[IND] Arc Control (Inductance) (Multiprocess Models)
Controls the dynamic properties of the arc to control the puddle. The 0% setting
gives a minimum inductance, that is a stiff, fast responding arc, and a small, fast
freezing puddle. The 99% gives maximum inductance, that is a soft, slow respond-
ing, low-spatter arc, and high puddle fluiditiy. Use FLUXCORE setting for Self
Shielded Flux Core.
Range: Solid wire 0-99% or FLUXCORE
Select a setting best suited for the application.
�
Inductance adjustment may change polarity; refer to polarity selection above.
AC Waveshape Control
Description
Balance Control (%EN) TIG Only:
Controls oxide cleaning. Increasing the setting reduces cleaning. Range is BALL, 50
- 99%. Stick is fixed at 50%. "BALL" sets the Balance to 30%. This is to allow the op-
erator to form a ball on the tip of the tungsten. It is not for normal welding operation.
See tips in Section 6-2.
AC Frequency (Hz): Controls arc width. Increasing the setting narrows the arc width.
Range is 20 to 400 Hz. See tips in Section 6-2.
A complete Parts List is available at www.MillerWelds.com
4
5
MENU
Tungsten Diameter Selection
Description
Each tungsten size has preset starting parameters specific to that diameter for optimized starting. Range
is 0.020 in. to 1/8 in. or 0.5 mm to 3.2 mm. To manually set starting parameters, see Section 15.
1
1 Amperage Button
2 Gas/Dig Button
3 Parameter Display
4 Setting Display
5 Amperage Adjustment Control
To access the User Setup menu, press and
hold the Amperage (A) and the Gas/DIG but-
tons until [USER] [MENU] is displayed. To
scroll through the user menu functions, press
and release the Gas/DIG button.
Rotate amperage adjustment control to ad-
just parameter setting.
To exit user menu, press Amperage and Gas/
DIG buttons at the same time and then re-
lease, or turn power off.
6 V-Sense Feeder
Optional - see Section 7-1 and 7-2 for more
information.
2
280589-A
OM-270536 Page 23
OM-270536 Page 23
OM-253086 Page 43