Section 6 - Dynasty 280 Operation; Dynasty 280 Controls - Miller Dynasty 280 Series Owner's Manual

SECTION 6 – DYNASTY 280 OPERATION

3-1. Dynasty 280 Controls

6-1. Dynasty 280 Controls
7
1 Standby Button
Use to put machine into low power con-
sumption mode.
�
This button can also be used to clear
some errors. See Section 11-5.
2 Amperage Adjustment Control
Use Amperage Adjustment
change preset amperage value. If a remote
control is used, preset amperage value is
the maximum amperage output available.
This control also functions as a parameter
change control while in the menu mode (see
Sections 6-2 thru 6-6).
3 Memory Card Port And Indicator
This port is used to add features to the ma-
chine and update software to the boards
within the machine. Indicator is lit while card
is being accessed (see Section 5-12).
OM-253086 Page 8
OM-253086 Page 34
SECTION 3
�
Complete Parts List is available at www.MillerWelds.com
1 4
8
4 Voltmeter
Displays actual rectified average voltage
when voltage is present at the weld output
terminals. It is also used to display parame-
ter descriptions while in the menu.
5 Ammeter
Displays actual amperage while welding and
control to preset amperage while idle. It is also used to
display parameter selection options while in
the menu.
6 Menu Button
Press button to scroll through available pa-
rameters for the selected process. Hold but-
ton to enter set-up mode (see Sections 6-2
thru 6-6).
7 Output ON Indicator
DYNASTY 280 OPERATION
3
5
6
Blue indicator illuminates when output is on.
8 Process Selector Control
Use to
processes:
� AC TIG - Used for welding aluminum.
� DC TIG - (DCEN) Used for welding mild
and stainless steel.
� DC Stick - (DCEP) Used for welding
steels.
� AC Stick - Used for welding steels if arc
blow is a problem while using DC Stick.
9 SD Logo
The memory card port uses an SD memory
card.
The SD logo is a registered trademark of
SD-3C LLC.
2
247222-D
select one of the following