Accessing User Setup Menu: Ac And Dc Stick - Miller Dynasty 280 Series Owner's Manual

6-6.

Accessing User Setup Menu: AC And DC Stick

3-6. Accessing User Setup Menu: AC And DC Stick
2
USER
Parameter/Setting Display
[HOTS] [ON]
[HOTS] [OFF]
Parameter/Setting Display
[RMT] [STD]
[OUT] [ON]
OM-253086 Page 12
�
Complete Parts List is available at www.MillerWelds.com
A complete Parts List is available at www.MillerWelds.com
3
4
MENU
Or
Arc Starting Method Selection
Description
Provides additional amperage while striking the electrode to prevent the electrode from sticking.
No additional starting amperage to assist in starting the electrode.
Trigger Mode Selection
Description
Typically used with a remote foot or hand control. RMT STD requires a maintained contact closure to ena-
ble weld output. Amperage can be controlled with a remote potentiometer, or it can be set at the control
panel.
Output on.
Weld output terminals are energized at all times when displays read [OUT] [ON].
No remote control or trigger required. Amperage can be controlled at the control panel or with a remote
potentiometer. Blue output on LED illuminates to indicate output is on.
1
1 Menu Button
Press and hold Menu button for approxi-
mately 2 seconds to access User Setup
menu. Use Menu button to cycle through pa-
rameters that can be set.
2 Parameter Display
3 Setting Display
4 Amperage Adjustment Control
Rotate Amperage Adjustment control to ad-
just parameter setting.
�
To exit menu, press and hold Menu but-
ton until Menu Off is displayed.
247222-D
OM-253086 Page 39