Connections - Miller Dynasty 280 Series Owner's Manual

A complete Parts List is available at www.MillerWelds.com
5-4.

Connections

Dynasty Front Panel
1
2
3
4
Rear Panel
8
6
A complete Parts List is available at www.MillerWelds.com
Maxstar Front Panel
1
2
9
4
5
wrench
crescent wrench
7
12
11
nutdriver
OM-253086 Page 24
chippinghammer
OM-253086 Page 4
A complete Parts List is available at www.MillerWelds.com
�
Complete Parts List is available at www.MillerWelds.com
1
2
1
9
4
9
5
8
7
12
6
11
Ref. 805496-B
Ref. 805496-B
2
10
2
2
10
10
5
7
12
11
Turn off power before connecting
to weld output terminals.
Do not use worn, damaged, under-
sized, or repaired cables.
1 Remote Control Receptacle (See Section
5-10)
2 Gas Out To Torch Connection
Requires an 11/16 in. wrench.
3 Work Lead Connection
4 TIG Torch, Stick Electrode Holder, Or Volt
Sense Feeder (Multiprocess Models)
5 Main Power Switch
Use switch to energize/de-energize
machine.
6 Optional Coolmate 1.3 Dedicated Power
Supply Receptacle
7 Supplementary Protector For Coolmate
1.3 Dedicated Power Supply
Included with optional dedicated Coolmate
1.3 power supply receptacle.
8 Gas In Connection
Fitting has 5/8-18 in. right hand threads, and
usually requires an 11/16 in. wrench. Maxi-
mum psi is 125.
9 Positive (+) Weld Output Connection
Work lead connection for TIG welding; elec-
trode holder connection for Stick welding
10 Negative (-) Weld Output Connection
TIG torch connection for TIG welding; work
lead connection for Stick welding
11 Ethernet (Insight models only)
RJ-45 port is for installation to a wired Inter-
net via DHCP, or static IP settings as se-
lected during setup configuration of the unit.
12 USB A (Insight Models only)
Use this port for installation of firmware.