Software Updates - Miller Maxstar 400 Owner's Manual

5-17. Software Updates

A. Reasons For Downloads Of Software Updates
• To get the latest feature and software improvements with future software updates.
• For all circuit board replacements, a software update is required to ensure proper unit operation.
• A software update is required to ensure proper software expansion operation of all purchased feature expansions.
B. Requirements
C. How To Download Software Updates
1. On your web browser, go to http://www.millerwelds.com/support/system-setup-and-software/tig-software.
2. Select System Installation Instructions (PDF) and follow the instructions.
D. Software Installation
1
OM-275857 Page 38
.
A complete Parts List is available at www.MillerWelds.com
2
.
2
Software updates may reset ma-
chine back to default values.
Card Requirements:
Full size memory card required.
1 Memory Card Port
2 Indicator LED
Insert card containing new software into
port while machine is on, (but not while
welding). Inserting card while welding
will interrupt the welding process.
LED indicator blinks green when ma-
chine is reading from or writing to the
card, and the meter displays go blank.
.
A computer with an SD memory card port, or SD
memory card reader is required to download soft-
ware updates.
The SD logo is a registered trademark of SD-3C LLC.
1
The update time may vary up to three
minutes. Do Not remove card while LED
is blinking green.
After successfully reading from or writ-
ing to the card, the LED switches from
blinking to continuous green, and the
meters illuminate. The machine is now
ready for use.
Troubleshooting:
Indicator LED is blinking red: Error up-
dating software, or software is not com-
patible. Try removing and inserting card.
Indicator LED is continuous red: Cannot
read card. Card might be bad.
273670-B