INFORMATION DISPLAY
U-BOOT SW
U-BASE SW
USAGE LOG
Error Log
My Settings Menu (5671)
Service Access Code: 5671 (see
page 28)
The My Settings service menu is used to customize the equipment user interface loc-
alization and Workouts default settings.
To learn about the R20 console My Settings service menu, refer to the TRM425 Owners
Manual:
Owners
l
MY SETTINGS
SAFETY CODE
SET UNITS
SET DEFAULT
WORKOUT TIME
SET MAX
WORKOUT TIME
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
The console upper boot software version information.
The console upper base software version information.
Shows workout usage information for each individual
workout including the number of times and the total accu-
mulated time the workout was used.
List of the equipment stored error event codes (stores a
maximum of 30 error codes).
"R20 How To Access Standard Service menus" on
Manual.
Enabled or disabled. When enabled, a user password (xxxx) is
required to use the machine.
Factory default: disabled
Sets units of measure to US Standard or Metric.
Default: U.S.
Controls whether workouts start with a default session time that is
different from the maximum session time.
Default: ON, 30 minutes
Range: 1 to 90 min
Use State: ON or OFF
If ON use must set a Default workout time in minutes.
Range: 1 to 240 min, NO LIMIT
Default: 60 min
Sets the maximum workout sesstion time.
Range: 1 - 90 min
Default: 90 min
4 Standard Service Menus
DESCRIPTION
DESCRIPTION
My Settings Menu (5671)
Page 33