Precor Precision 400 Series Service Manual page 127

belt. Brace yourself using the handlebars or side handrails. Push the Quick Start but-
ton once in position.
CAUTION: You have approximately 3 seconds before the treadmill running belt
begins to move after pressing Quick Start. Ensure you are in the proper position.
WARNING: Press the safety stop key if the towel becomes loose to prevent it from
being pulled into the treadmill's rollers.
4. The treadmill will begin to run at 1 mph. Allow the treadmill to run for one minute while
keeping the towel firmly in place.
WARNING: Do not adjust the treadmill's speed or run it higher than 1 mph.
5. After one minute, stop the treadmill by pressing the STOP button.
6. When the belt has fully stopped moving, remove the STOP key tether, exit the tread-
mill, and turn the power switch to OFF.
7. Grasp both sides of the towel and run it up and down the length of the belt several
times to clean the top of the deck.
8. Remove the towel from beneath the belt.
9. Turn the power switch to ON.
10. Verify operation and return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
8 Preventative Maintenance
Running Belt and Deck Cleaning Procedure
Page 120