INFORMATION DISPLAY
HOUR METER
U-BOOT SW
U-BASE SW
USAGE LOG
Error Log
My Settings Menu (5671)
Service Access Code: 5671 (see
page 39)
The My Settings service menu is used to customize the equipment user interface loc-
alization and Workouts default settings.
To learn about the R20 console My Settings service menu, refer to the TRM425 Owners
Manual:
Owners
l
MY SETTINGS
SAFETY CODE
SET UNITS
SET DEFAULT
WORKOUT TIME
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
again from "0".
The total number of hours that the unit took to accumulate
unit miles.
This value is stored in the upper PCA in the console so if
that PCA is replaced the hours of use would start again
from "0".
The console upper boot software version information.
The console upper base software version information.
Shows workout usage information for each individual
workout including the number of times and the total accu-
mulated time the workout was used.
List of the equipment stored error event codes (stores a
maximum of 30 error codes).
"R20 How To Access Standard Service menus" on
Manual.
Enabled or disabled. When enabled, a user password (xxxx) is
required to use the machine.
Factory default: disabled
Sets units of measure to US Standard or Metric.
Default: U.S.
Controls whether workouts start with a default session time that is
different from the maximum session time.
Default: ON, 30 minutes
Range: 1 to 90 min
Use State: ON or OFF
4 Standard Service Menus
DESCRIPTION
DESCRIPTION
Standard Service Menus
Page 44