Touchpanel Removal - Crestron Isys TPS-3000L Operation Manual

6.4" Lectern/Wall Mounted Touchpanel
22 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L
3. Insert the touchpanel (without its faceplate) into the mounting option and
align the four screw holes.
4. Insert and tighten the four supplied screws (finger tight and then using a #1
Phillips screwdriver, tighten an additional 1/8-turn).
5. Insert the five buttons. If the buttons are engraved, verify that the placement
of the each button matches the programming.
6. Cover the mounted unit with the faceplate. Refer to the illustration after this
paragraph for guidance.
Exploded View for Mounting the TPS-3000L in the Optional BB-3000L Back Box
TPS-3000L
FACEPLATE
Optional custom engraved keys can be ordered separately by using the Crestron
Engraver Software. Version 2.0.0.9 or later is available from the Downloads |
Software Updates section of the Crestron website (www.crestron.com).
NOTE: If it is necessary to remove the touchpanel, secure and label the attached
cables before disconnecting them from the back of the touchpanel.

Touchpanel Removal

If it is necessary to remove the touchpanel after it has been installed into a mounting
surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #1 Phillips tip screwdriver.
Crestron Isys™ TPS-3000L
1
#6-32 x 1 " (SR-06-32-1R5000-2)
2
PAN HEAD SCREW, QTY. 4
SUPPLIED BY CRESTRON
Operations Guide – DOC. 6077
BB-3000L