Hardware Hookup - Crestron Isys TPS-3000L Operation Manual

6.4 inch lectern/wall mounted touchpanel
Hide thumbs Also See for Isys TPS-3000L:
Table of Contents

Advertisement

Crestron Isys™ TPS-3000L
RS-232 MENU
TIMEOUT SETTINGS
DIAGNOSTICS MENU
Operations Guide – DOC. 6077
6.4" Lectern/Wall Mounted Touchpanel
RS-232 Menu
The touchpanel allows for four RS-232 communication methods:
Console (i.e. loading programs)
Control (i.e. non-Crestron device)
Touch output (communication of touch coordinates to an external device)
External touch screen input.
Touch the communication option to select communication parameters and then
select Save and Return to save the RS-232 settings and return to the SETUP
MENU.
Timeout Settings
The touchpanel display can be turned off (standby mode) when not in active use.
Select the Timeout button on the SETUP MENU to reveal the TIMEOUT
SETTINGS display, shown to the left. This setting turns the display off when the
touchpanel is inactive for a specified time. Touch the screen to awaken the
touchpanel and the last screen to be displayed reappears. The time value, represented
by xxx in the illustration, can range from 0 (disables the timeout) to 120 (minutes).
Two buttons, UP and DOWN, increase and decrease the timeout, respectively.
Select the Return button to save the timeout setting and return to the SETUP
MENU.
Diagnostics Menu
The Diagnostics button from the MAIN MENU should only be used under
supervision from a Crestron customer service representative during telephone
support. The options available from the DIAGNOSTICS MENU, shown to the left,
are numeric in nature and their interpretation is beyond the scope of this manual.
NOTE: The "About..." button will display a screen indicating the current version
of firmware residing on the touchpanel.

Hardware Hookup

The TPS-3000L can be mounted in a wall or inside a lectern. Make the necessary
connections as called out in the illustration that follows this paragraph. Refer to
"Network Wiring" on page 7 before attaching the 4-pin connector. Apply power after
all connections have been made.
CAUTION: Do not remove the tape that covers the photosensor. Doing so can short
the board and damage the touchpanel.
CAUTION: Do not apply excessive pressure to the touchscreen display during
handling (mounting/installation). Doing so can crack the screen and damage the
touchpanel.
6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L • 17

Advertisement

Table of Contents
loading

Table of Contents