Touchpanel Removal - Crestron Isys TPS-4L Operations & Installation Manual

3.6-Inch Wall Mount Touchpanel
12 • 3.6-inch Wall Mount Touchpanel: Isys
Insert the TPS-4L Into the Mounting Surface
7. Tighten the mounting screws evenly and only enough to compress the
mounting clips and secure the TPS-4L squarely in the mounting surface. Do
not overtighten the screws.
NOTE: If it becomes necessary to remove the touchpanel from the mounting
surface, the original mounting clips cannot be reused to remount the touchpanel.
Additional mounting clips are available in the Mounting Kit WMKB-4L identified in
"Mounting Options" on page 8.
Installing the Bezel
Use the Crestron Engraver software package to obtain a custom-engraved bezel for
the TPS-4L. Install the bezel as follows.
1. Carefully position the bezel over the face of the touchpanel.
2. Ensure that the bezel is oriented properly and press against the TPS-4L until
the bezel snaps into place.

Touchpanel Removal

If it is necessary to remove the touchpanel after it has been installed into a mounting
surface, complete the following steps in the order provided to remove the
touchpanel. The only tool required is a #2 Phillips tip screwdriver.
1. Lift one edge of the bezel to free it from the touchpanel, and lift it off. Do
not apply excessive pressure to the touchscreen.
2. Loosen and remove the screws that secure touchpanel to the mounting
option in use.
3. Using equal pressure, carefully remove the touchpanel from the opening.
If necessary, secure and label the attached cables before disconnecting them from the
back of the touchpanel.
®
TPS-4L
Crestron Isys
Operations & Installation Guide - DOC. 6449
®
TPS-4L