Table of Contents
Advertisement
6.4" Lectern/Wall Mounted Touchpanel
20 • 6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L
NOTE: When sending balanced audio from a CNX-BIPAD8 or CNX-PVID device,
only the Positive (+) and Negative (-) wires are to be connected to the touchpanel.
Do not connect the Shield (S) wires.
AUDIO Pinouts-Unbalanced
PIN #
DESIGNATION
1
S
2
R+
3
R-
4
L+
5
L-
6
S
NOTE: Using two jumpers, connect R Shield to R - and L Shield to L - respectively
at the TPS3000 Audio Input connector. Refer to the following diagram.
Wiring for Unbalanced Audio
+
-
+
-
S
R
R
L
L S
+
+
Jumpers
NTSC/PAL INPUT
This port provides unbalanced composite and S-video input (using BNC connectors)
or balanced video input (using 6-position mini-phoenix) for video signals. Both sets
of inputs support both NTSC and PAL formats. Balanced video format is typically
used when distributing video via CAT 5 (i.e., from a Crestron CNX-PVID8x3 or
8x4). Unbalanced video is typically used when distributing video via coaxial cable.
NOTE: Cable runs for balanced video should not exceed 500 feet (152.4 meters)
and cable runs for unbalanced video should not exceed 100 feet (30.5 meters). For
distances greater than these specified lengths use a distribution amplifier.
NTSC/PAL Balanced Video Input Pinouts
PIN #
DESIGNATION
1
Y(+)
2
Y(-)
3
Y(S)
(continued on next page)
Crestron Isys™ TPS-3000L
DESCRIPTION
Ground
Right Input (Positive)
Right Ground
Left Input (Positive)
Left Input Ground
Ground
DESCRIPTION
Luminance (Positive)
Luminance (Negative)
Luminance (Shield)
Operations Guide – DOC. 6077
Advertisement
Table of Contents
