Crestron Isys TPS-3000L Operation Manual page 13

Crestron Isys™ TPS-3000L
Operations Guide – DOC. 6077
6.4" Lectern/Wall Mounted Touchpanel
Lectern Mounting
If the touchpanel is to be installed into a lectern, the touchpanel must be set to the
"Inverted" configuration. The "Inverted" configuration provides optimum viewing
when installed into a lectern. This configuration requires the pushbuttons to be
placed on the right side of the screen the screen orientation set to "Inverted"
operation (refer to "Screen Settings" on page 15 for instructions), and the connectors
to be located at the top of the touchpanel. Refer to the following diagram. Before
installing the touchpanel in the "Inverted" configuration, the pushbuttons must be
reoriented to match the position of the touchpanel. Follow the instructions below to
reorient the pushbuttons.
Pushbutton Layout and Join Number Assignment-Lectern Mount
NOTE: This Procedure should be done before installing the touchpanel.
Required Tools
#1 Phillips tip screwdriver
1. Place the touchpanel on a flat surface.
2. Remove the faceplate (if installed) and the pushbuttons from the
touchpanel. Number the pushbuttons 1 through 5 (with 1 being the button in
the top position) as they are removed.
3. Use a #1 Phillips screwdriver to remove the two screws that hold down the
pushbutton circuit board. Refer to the following diagram for screw
locations.
Pushbutton Circuit Board (Top View)
+
J2
J1
Ribbon Cable
+
6.4 Inch Lectern/Wall Mount Touchpanel: Crestron Isys™ TPS-3000L • 9
1
2
3
4
5
Screws